Codey Rocky

Introducing your new coding companion. Codey Rocky, a coding robot for STEAM education. A tool that enables beginners to code within minutes. This three-in-one coding expert is a combination of robotics, programming, and coding together making it perfect for entry-level coding. Equipped with over 10 electronic modules like a sound …

Grove Inventor kit with Micro:bit

Grove Inventor Kit for micro:bit The BBC micro:bit is a pocket-sized computer that can easily realize your creativity without much electrical and coding knowledge. There are numerous possibility of creation you can dig out by micro:bit, from robots to musical instruments. However if you want to create more things, just …

How to add rechargeable lithium battery to the mBot

How to install battery under mCore device

  1. Place the battery into Battery Holder
  2. Please ensure the wire should pass from the side slip.

  1. Secure the holder underneath the mBot mCore case.
  2. Connect the battery wire to the JST connector on the mCore board.

How to charge a battery?

  1. The battery can be charge using USB port on the mBot.
  • The USB can be connected to computer or Australian certified USB wall adapter.

How long battery needs for the charging?

  1. Battery can take up to 3 to 4 hours to charge. Please ensure the battery is not left charged over a long time of period. The LED next to battery JST connect will indicate Green or Red colour for fully charged and not charged condition of the battery respectively.


  1. Battery should never be used without plastic enclosure case shown in Assembly step 1.
  • Never leave battery charging unattended.
  • Ensure the water or any liquid is not spilled over the electronics.

Product links

mBot battery –


Linkit Platfroms By MediaTek

MediaTek Labs is an Internet of Things (IoT) developer program. Here you can find the tools to create pre-commercial prototypes based on Wearables and IoT chipsets from MediaTek, a pioneering fabless semiconductor company, using HDKs offered by our partners. At Pakronics, we offer a range of MediaTek platforms. LinkIt™ Smart 7688 …

Omega2 – Linux computer

A simple job took them to new product and eventually starting a company around it. This is the story behind Onion, strange but yes Onion. As project they started using Arduino led them to make a simpler IoT device for software developer. As many of you may not know the main …

Step 6-Reading analog data input!

What you have learned so far with Pakronics… Through previous blogs (#1, #2, #3, #4, and #5), we looked at working with Genuino board, Arduino software IDE and range of hardware components. We also learnt how to interface external components – basic input and output devices, with Genuino board. An …

Grove – Speaker

#SeeedStudioInAustralia Check out Grove – Speaker for your next audio project. It has power amplification and voice outputs with on-board potentiometer to adjust loudness. With different input frequency, the loud-speaker generates different tones. Buy Grove – Speaker from Pakronics:

Step 4-Connecting Genuino Board to Real-World!

The main purpose of Genuino (yes, the open-source microcontroller board) is to build systems that could interact with outside world i.e., accept input or data (switching input, sensor signal, keypress), process it and produce an output (turn on/off an LED, motor speed control, display message or value etc.). There are different …

Arduino WiFi Shield 101

#ArduinoInAustralia Arduino WiFi Shield 101 is the new shield based on ATWINC1500 for all your IoT needs. The shield supports easy to use library that allows you to connect Arduino board to internet. The SSID and password are required and no further configuration is needed. It also features a complete …

Steam Sensor

#DFRobotInAustralia Checkout the Steam Sensor from DFRobot. Easy to connect to the Arduino IO Expansion shield directly. The output voltage is in proportion to the humidity of the sensor surface. Applications: Simple rain detector Cheap steam level switch Touch sensor based on humidity Specification: Power supply: 3.3v or 5v Output …